VME-3113A - VMIC VME-3113A Analog I/O - Scanning 12-bit Analog-to-Digital Converter Board with Built-in-Test

VME-3113A - VMIC VME-3113A Analog I/O - Scanning 12-bit Analog-to-Digital Converter Board...

VMIC VME-3113A Analog I/O - Scanning 12-bit Analog-to-Digital Converter Board with Built-in-Test Simple Type: Analog I/O Module

For Resellers and High Volume Orders:
Please request a quote to obtain preferred pricing.

33 kHz Conversion Rate
5 x 106 Input Impedance
64 Differential or Single-Ended Inputs
Barrier Terminal Strips Available
Compatible with VMIC's Line of Intelligent I/O Controllers (VMIVME-90XX Series) and Universal I/O Controllers (VMIVME-9300 Series)
Continually Digitizes All Input Channels and Stores the Results in Dedicated Channel Dual-Port Registers (Autoscanning Mode)
Five Operating Modes Plus Test Mode (Autoscanning Mode (Gain = 1), Random Poll Mode, Random Interrupt Mode, Scanning Poll Mode, Scanning Interrupt Mode)
Jumper-Programmable Gain 1, 10, 100, 200, and 500
Low-Level and High-Level Inputs: ±10 mV to ±10 V
Optional Low Pass Filter
Overvoltage Protected Inputs
Powers Up in Autoscanning Mode No Software Initialization Required
See compatible Analog I/O Signal Conditioning Boards
Selectable A/D Ranges of 0 to +10 V, ±5 V, and ±10 V
Selectable Output Code: Binary, Offset Binary, Two's Complement with Sign Extension
Supported by VMIVME/SW-9390 Universal I/O Driver (UIOD)
Supports Real-Time and Off-Line Built-in-Test
The Number of Channels to Be Scanned Are Jumper Selectable Between 2 and 64 Channels
Triple 16-bit User-Programmable Interval Timers Support Scanning of All Channels at Periodic Intervals (Cascadable to 48 bits)
VMEbus Interrupts May Be Programmed to Interrupt Upon Completion of a Single A/D Conversion or Upon Completion of a 2- Through 64-Channel Scan

General